Model 3/Y Height Sensor Brackets

Model 3 Height Sensor Brackets

Bolt-On mounting brackets for your height sensors, utilizing factory bolting locations to simplify installation.

Model 3 utilizes locating pin on inner fender well and a self tapping screw.  

Model Y uses 2 self taping screws to secure mount to inner well.

The rear upper sensor mount. Drill the square hole to a round 1/4"  hole, then bolt on the brackets.

determine the length of rods.

After adjusting your shock bodies to the proper length to maximize your suspension travel, with the suspension hanging rotate the sensor just short of the maximum accurate range, and cut the threaded rod to make the linkage the proper length.  Compress suspension to verify not over rotating in the other direction